Marantz SR6003 - Manual (Page 60)

57
ENGLISH
BASIC
CONNECTIONS
BASIC OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
ADV
ANCED
OPERA
TION
PRESET SCAN
2.
1.
3.
6.
5.
1. Press the TUNE button twice within two
seconds on the remote controller.
2. Press the BAND button to select XM band.
3. Press the P.SCAN button on the remote
controller.
4. Preset channels are recalled in sequence (No.1
→ No.2 → etc.) for about 10 seconds each. The
time changes by the received condition. No
stored preset number will be skipped.
5. Pressing the 2 button during prescanning
speeds up scanning.
Also, pressing the 1 button returns to the
previous preset channel.
6. When the desired preset channel is received,
cancel the preset scan operation by press the
P. SCAN button.
CLEARING STORED PRESET CHANNELS
You can remove preset channels from the memory
using the following procedure.
2.
3.
2. 3.
1. Recall the preset number to be cleared with
the method described in “PRESET SEARCH
MODE”.
2. Press the MEMORY button on the front panel
or press the MEMO button on the remote
controller.
3. The stored preset number blinks in the display
for 5 seconds. WhiIe blinking, press the CLEAR
button on the front panel or CL button on the
remote controller.
4. “xx CLEAR” appears on the dispIay to indicate
that the specified preset number has been
cleared.
Notes:
• To clear all stored preset channel, press and hold the
T-MODE and the ENTER buttons on the unit for
two seconds.
• There are 50 preset channels prepared at the factory
default. The 50 channels are all set to “CHANNEL
001”. Each channel can be stored in the preset
memory. You can search for only the preset
channels.