Multi-Tech Systems ISIHP-2S - Manual (Page 44)

Software/Driver Installation
44 MultiModemISI Hybrid Series, ISIHP-2S/2U
ISDN TA Configuration Utility
1. Before you start the ISDN TA Configuration utility, disconnect the
ISIHP-2S/2U by removing the RJ-45 cable from the ISDN jack.
2. Make sure Windows NT Remote Access Service (RAS), or any
other application that is using the modem, is shut down. To shut
down RAS, click Start, Programs, and then Administrative Tools
(Common). Then click Remote Access Admin and click Server,
which will indicate whether or not RAS is running. If it is running,
click Stop Remote Access Service.
3. Insert the Config Utility diskette into the floppy drive.
4. From the main desktop of your PC, select Start, Settings, Control
Panel. Click on the Add/Remove Programs icon. Click Install.
5. The dialog box Install Program from Floppy Disk or CD-ROM
appears. Click Next. The Run Installation Program dialog box
appears. Click Finish.
6. The Welcome dialog box for the ISDN TA Configuration Utility
Setup program appears. Click Next.
7. The Choose Destination Location dialog box appears.
8. The Setup dialog box appears.
9. The Information dialog box appears. Click OK.