Multi-Tech Systems ISIHP-2S - Manual (Page 50)

Software/Driver Installation
50 MultiModemISI Hybrid Series, ISIHP-2S/2U
ConfigMenu Configuration Utility
Use the ConfigMenu configuration utility with computers using DOS
or Windows 3.x operating systems. ConfigMenu is installed in the
TAs as part of the firmware.
To use ConfigMenu:
1. Start a data communication program and select the COM port
where the TA is connected.
2. In the communication program dialog box, type AT@CONFIG
and press ENTER. ConfigMenu’s Main Menu appears (see screen
below).
3. To select menu item, type its number and press ENTER. A
submenu then appears where you can make selections. At the
lowest level, you can change a configuration option by selecting a
number or typing a value and pressing ENTER.
4. When you finish, close ConfigMenu.
5. Use the &W command to save your new configuration and to load
it automatically when the TA is turned on.