Multi-Tech Systems ISIHP-2S - Manual (Page 53)

Software/Driver Installation
MultiModemISI Hybrid Series, ISIHP-2S/2U 53
SCO Open Server 5 Driver Installation
The installation utility provided by SCO is called custom. This section
provides a brief guide for opening the utility and installing the driver.
The instructions below should be used only on SCO Open Server 5
systems. When you have completed the steps below, go to Multi-Tech
Installation Script, which immediately follows this section.
1. If installing the driver from your default floppy drive, type custom
and press ENTER to open the custom utility. If using a nondefault
drive, you must inform your system of the disk drive from where
you are doing the installation and the size and capacity of the
diskette(s).
2. Select Software and press ENTER.
3. The main menu displays a list of options. Press ENTER to select
the highlighted item (default): Install.
4. Select From comsco and press ENTER.
5. Make sure the driver diskette is in the floppy diskette drive and
then press ENTER to select the highlighted item (default): Floppy
Disk Drive 0. The following message appears:
Examining media. Please wait
6. The system recognizes you are installing the Multi-Tech Serial
Card Driver and prompts you to select the type of installation.
7. Select Full Installation and press ENTER to continue. The
following messages appear:
Extracting Files...
Executing Multi-Tech Serial Card Driver Init Script...
8. When installation finishes, this prompt appears:
Do you wish to continue ( y / n / q ):?
Type Y and press ENTER. Proceed with the next section, Multi-
Tech Installation Script.