Multi-Tech Systems ISIHP-2S - Manual (Page 6)

6 MultiModemISI Hybrid Series, ISIHP-2S/2U
Hardware Installation
Introduction
This section describes how to install the ISIHP-2S/2U server card into
the PCI bus on your personal computer, which involves
• Opening your PC
• Setting card configuration (determining I/O address DIP-switch
setting and IRQ jumper setting)
• Installing the card into the PC
Computer Requirements
• Pentium-based PC or compatible with PCI bus architecture
• Microsoft Windows 95, Windows NT version 4.0, SCO Open Server
version 5.0, Novell NetWare, or Linux
• At least one floppy drive
• 800 blocks of hard disk space for UNIX, 100K bytes for Windows
NT, 34K bytes for Windows 95, 50K bytes for Novell
Shipping Contents
• ISIHP-2S/2U card
• RJ-45 ISDN cord (2)
• ISIHP Driver Disk set with ISDN TA Configuration Wizard
• Quick Start Guide