Manitowoc Ice Q - Manual (Page 11)

Part Number 000001530 2-1
Section 2
Installation Instructions
General
These instructions are provided to assist the qualified
installer. Check your local Yellow Pages for the name of
the nearest Manitowoc distributor, or call Manitowoc Ice,
Inc. for information regarding installation and start-up
services.
Ice Machine Installation Options
HEAD SECTION
The ice machine head can be installed with the electrical
inlet, water supply inlet and refrigeration tubing entering
from the back or top of the ice machine.
The ice machine water drain must exit the back of the
ice machine.
Cut the top cover for top routing of electrical inlet, water
supply inlet or refrigeration lines.
1. Prior to cutting, mount top cover onto ice machine.
2. Locate the area that will need to be cut and mark the
top cover.
3. Using a tin snips, cut top cover as needed:
A. Do not cut out entire area! Cut up to 1/8 inch to
marked line.
B. Cut out only what is needed. (If routing only
refrigeration lines out the top, cut just enough to
route these lines.)
C. Do not cut out the entire corner area.
Important
Failure to follow these installation guidelines may
affect warranty coverage.
TUBING CAN BE
ROUTED OUT TOP
SV1769A
TUBING CAN BE
ROUTED OUT
BACK OF THE ICE
MACHINE WITH
PROVIDED 90 °
ELBOWS
TRIM TOP COVER
IN THIS AREA
SV1768B