Moyer Diebel MD-66 - Manual (Page 19)

11
Installing the Upper Spray Arm Assembly
Installation
1. Upper Wash Arm Rear Support
The rear support holds the wash
arm and serves as a guide when
the upper wash arm is pushed
to the toward the connection
flange at the rear of the
dishwasher.
2. Connection Flange
The connection flange holds the
wash arm securely in place when
the upper wash arm is placed in
position. In addition, the
connection flange holds the wash
arm o-ring in position.
3. O-ring
The wash arm o-ring rests in the
center of the connection flange
and forms a water-tight seal when
the upper wash arm is in place.
Upper Wash Arm
Rear Support
O-ring
Connection
Flange
1
2
3
Upper Wash Arm Assembly
Wash Arm Connection
Flange Pin Front Support
Rear Support
Connection
Flange
The upper wash arm assembly is suspended from the top of the dishwasher hood interior
by front and rear supports. Follow the instructions and illustrations below to install the
upper wash arm assembly.
Upper wash arm assembly shown installed.
(Note that the Wash Arm Connection Flange Pin is seated in the Connection Flange.)
Make sure the upper spray arm o-ring is in good condition and fits
securely in the connection flange before installing the upper
wash arm assembly.
Components