Moyer Diebel MD-66 - Manual (Page 9)

1
Installation
!!ATTENTION!!
Use caution when moving or lifting the dishwasher to prevent damaging the dishwasher
or the installation site. Check doorway and passageway clearance before moving the dishwasher.
Remove dishwasher front panels and check under the machine base for obstructions before moving.
1. Inspect the dishwasher for shipping damage.
2. Check the dishwasher interior for
curtains, panels and other supplies.
3. Lift the dishwasher off the shipping pallet
and move the machine near its
permanent location.
4. Leave a minimum of 6" between walls
and the rear of the dishwasher.
5. Level the dishwasher side-to-side and
front-to-back using a bubble level.
The dishwasher legs are adjusted by
screwing them in or out.
6. Do not remove tags attached to the
utility connections.
7. Remove the protective film from the
dishwasher exterior.
8. Remove any foreign material from the
dishwasher interior.
Receiving
Wall Clearances
6"
6"
1. Inspect the outside of the dishwasher carton for signs of damage.
2. Remove the carton and inspect the dishwasher for damage.
3. Check for any options or accessories that may have shipped with your dishwasher.
4. Turn to the front of this manual and follow the instructions to register your
product online or by fax.
NOTE:
The installation of your dishwasher must be performed by qualified service personnel.
Problems due to improper installation are not covered by the Warranty.
NOTE:
The installation of the dishwasher must comply with all local electrical, plumbing, health and
safety codes or in the absence of local codes, installed in accordance with the applicable
requirements in the National Electrical Code, NFPA 70, Canadian Electrical Code (CEC),
Part 1, CSA C22.1; and the Standard for Ventilation Control and Fire Protection of
Commercial Cooking Operations, NFPA 96.