Installing the upper spray arm assembly, Installation – Moyer Diebel MD-66 User Manual
Page 21
13
Installing the Upper Spray Arm Assembly
Installation
3
4
5
Upper Wash Arm
Rear Support
Upper Wash Arm
Front Supports
Upper Wash Arm Assembly
Connection Flange
1
2
The upper wash arm assembly is shown resting on the
upper wash arm rear support as it slides toward the connection flange.
The upper wash arm assembly is shown resting on the
upper wash arm rear support as it slides toward the connection flange.
1. Open the dishwasher access
doors and check the location
and condition of the connection
flange o-ring. Replace the
o-ring if it is worn or damaged.
Place the upper wash arm rear
guide pin in the rear support so
the wash arm hangs in the
support.
2. Slide the upper wash
arm toward the rear of the
dishwasher making sure the
rear guide pin is centered in
the rear supports.
3. Raise the front of the wash
arm so the connection flange
pin mates with the connection
flange pin slots.
4. Swing the front of the wash
arm up toward the front of the
dishwasher.
The wash arm front guide pin
should be positioned close to
the door opening and before
the front wash arm supports.
5. Slide the upper wash arm
forward as far as it will go
making sure that the front
guide pin is above the front
support notched cut-out.
Lower the upper wash arm so
the front guide pin seats
securely in the front support
notch. Installation is complete.
Installation