Moxa Technologies CP-104UL - Manual (Page 53)

Software Installation
Smartio CP-104UL User’s Manual 3-39
Loading the Driver
Having completed the setup, now you can load the driver BIN\DP-DRV.EXE at the DOS prompt.
The driver will detect the board you installed automatically. If the board(s) is(are) detected, a
message similar to below will show:
Smartio/Industio Family DOS driver Version 1.5
Setup driver …
CP-134U series (Bus= x ,Dev=y) : OK!
Device driver setup O.K.
It means that the CP-134U Series driver is installed properly. At this point, you are ready to
execute applications that support API-232 functions, or start developing applications using API-
232 library.
Unloading the Driver
To unload (release) the driver from memory, type DP-DRV/Q at the DOS prompt.
Linux
The Linux driver for MOXA’s multiport serial boards supports the following products:
! Universal PCI Boards: CP-168U, CP-104UL, CP-104JU, CP-134U, CP-134U-I, CP-132UL, CP-
132UI
! PCI Boards: C168H/PCI, C104H/PCI, C104HS/PCI, CP-114, CP-114I, CP-114S, CP-114IS, CP-132,
CP-132I, CP-132S, CP-132IS
! ISA Boards: C168H, C168HS, C168P, C104H, C104HS, C104P, CI-104J, CI-104JS, CI-134, CI-
134I, CI-134IS, CI-132, CI-132I, CI-132IS
! cPCI Boards: CT-114I
The following steps are using CP-168U as an example.
Follow the steps below to install the driver under Linux.
1. # mkdir moxa
# cd moxa
# tar xvfz mxser.tgz
2. #cd mxser
#make clean; make install
3. # cd /moxa/mxser/driver
# ./msmknod
4. # modprobe mxser
(If you install ISA Boards, please type commend # insmod mxser ioaddr=0x???, 0x???, 0x???,
0x???
<- 1st ISA, 2nd ISA, 3rd ISA, 4th ISA)
Using /lib/modules/2.4.20-8/kernel/drivers/char/mxser.o