Moxa Technologies CP-104UL - Manual (Page 54)

3-40 Smartio CP-104UL User’s Manual
Warning: loading /lib/modules/2.4.20-8/kernel/drivers/char/mxser.o will taint the kernel: no
license
See http://www.tux.org/lkml/#export-tainted for information about tainted modules
MOXA Smartio/Industio family driver version 1.7
Tty devices major number = 30, callout devices major number = 35
Found MOXA CP-168U series board(BusNo=2,DevNo=13)
Module mxser loaded, with warnings
5. You can use Moxa diagnostic utility to verify the driver status.
# cd /moxa/mxser/utility/diag
# ./msdiag
== MOXA Smartio/Industio Family Multiport Board Status Utility(1.1) ==
Tty Device Major Number= 30.
Callout device Major Number= 35.
Board 1 : CP-168U series (BusNo=2, DevNo=13)
Port 1: 0xac00, max. baud rate = 230400 bps.
Port 2: 0xac08, max. baud rate = 230400 bps.
Port 3: 0xac10, max. baud rate = 230400 bps.
Port 4: 0xac18, max. baud rate = 230400 bps.
Port 5: 0xac20, max. baud rate = 230400 bps.
Port 6: 0xac28, max. baud rate = 230400 bps.
Port 7: 0xac30, max. baud rate = 230400 bps.
Port 8: 0xac38, max. baud rate = 230400 bps.
6. You can use Moxa terminal utility to test tty port.
# cd /moxa/mxser/utiltiy/term
# ./msterm
SCO
The SCO driver for MOXA’s multiport serial boards supports the following products:
! Universal PCI Boards: CP-168U, CP-104UL, CP-104JU
! PCI Boards: C168H/PCI, C104H/PCI, C104HS/PCI
! ISA Boards: C168H, C168HS, C168P, C104H, C104HS, C104P, CI-104J, CI-104JS
Follow the steps below to install the driver under SCO. Moxa provide the following SCO Version:
! SCO Open Server
! SCO UnixWare 7
! SCO UnixWare 2.1
The following steps are using CP-168U under SCO OpenServer as an example. If you want to
install under SCO UnixWare 7 or SCO UnixWare 2.1, the installation procedures are similar as
SCO OpenServer.
1. Copy the driver file .tar to your host.
2. #tar xvf <driver tar file>