Miele KM5947 - Manual (Page 19)

Sensor switches
The control panel on your ceramic
cooktop is equipped with electronic
sensor switches. They respond to finger
contact.
To operate the cooking zones, simply
touch the corresponding sensor
switches. Every response of the sensor
switches is acknowledged with an
acoustic signal.
Take care to touch only the desired
sensor switch in the middle with your
finger vertical, and keep the control
panel clean with nothing placed on
top of it. Otherwise, the sensor areas
may not respond, or unintentional
commands may be given, even
causing the cooktop to automatically
switch off (see the section on "Safety
Switch-Off"). NEVER place hot
cookware on the sensor switches.
The electronic unit underneath might
be damaged.
Switching on
Begin by switching on cooktop and
thean the desired cooking zone.
Do not leave the appliance
unattended during operation!
Switching on the cooktop
^ Tap the ON/OFF sensor s.
A
0 appears in each of the cooking
zone displays. If no further information
is entered within the next few seconds,
the cooktop will shut off for safety.
Switching on the cooking zone
^ By touching the - or + sensor
switches, select the desired power
setting between
1 and 9 or the
keeping warm function.
If you begin with -, you select cooking
with Auto heat-up (see "Auto heat-up").
If you begin with +, you select cooking
without Auto heat-up.
If you would like to switch on another
cooking zone, for which the
0 has
already gone out, briefly press - or +
once. The
0 appears, and you can
select a power setting (with or without
Auto heat-up).
Operation
19