Miele WT 945 S WPS - Manual (Page 12)

– Ideally load the maximum amount
specified for the programme you are
using.
This way energy and water
consumption will be kept to a
minimum.
– Use the QUICK WASH programme
for small loads.
– Use the Short wash option for lightly
soiled laundry.
– A main wash (programme without
pre-wash) is sufficient for cleaning
normally soiled laundry.
– Use the Soak option for heavily
soiled laundry. The wash
temperature can be reduced for the
main wash when using the additonal
soak option.
– Use the additional option Soak
instead of Pre-wash with heavily
soiled laundry. If Soak is followed im-
mediately by a main wash the same
suds are used.
– Do not exceed the amounts of
detergent which may be
recommended by the manufacturer
on the packaging.
– Reduce the amount of detergent with
smaller loads (approx. 1/3 less than
the amount recommended can be
used when washing a half load).
– Load recognition can cause the
duration of a programme to vary
greatly. The main wash may be
shortened and a rinse cycle omitted
depending on the amount of laundry.
– Select a high spin speed for the
wash programme, as well as for the
Thermospin, if tumble drying the
laundry afterwards. This saves time
and energy.
Washing and drying environmentally
12