Hardware installation – Moxa Technologies Moxa Smartio C168H User Manual
Page 13
Smartio C168H/PCI User's Manual
2-1
2
2
2
2
2
Hardware Installation
The installation of the Smartio C168H/PCI consists of hardware and software
installation. The respective sections of the operating systems in the next chapter will
discuss more about the software installation. The hardware installation is described
in this chapter.
The no-switch-no-jumper Smartio C168H/PCI board hardware configuration for
IRQ number and I/O addresses is automatically assigned by the PCI BIOS. Hence,
the board MUST be plugged first before installing the software driver.
Installing the Smartio C168H/PCI Board
Step 1:
Power off the PC.
Warning!
Make sure your system is switched off before you start installing
any board. If you don’t, you may risk damaging your system and
the board.
Step 2:
Remove the PC cover.
Step 3:
Remove the slot cover bracket if there is any.
Step 4:
Plug the Smartio C168H/PCI(s) in the free PCI expansion slot(s) of the
PC.
Step 5:
Fasten the holding screw to fix the control board in place.
Step 6:
Replace the system cover.