Moxa Technologies Moxa Smartio C168H - Manual (Page 4)

About This Manual
This manual is composed of six Chapters and one Appendix. This manual is written for installer, system
administrator and software programmer.
If you are a first-time installer and system administrator, we recommend you to go through the whole
manual except Chapter 4 “Serial Programming Tools”.
If you are a software programmer, you may refer to Chapter 4 “Serial Programming Tools”.
If you need cable wiring information, please see Chapter 5 “Connection Option (Opt8x) and Cable
Wiring”.
If you encounter any problem during installation, please refer to Chapter 6 “Troubleshooting”.
Chapter 1 Introduction
This chapter gives the overview and features for C168H/PCI. Check-list and overall installation guide are
also included.
Chapter 2 Hardware Installation
This chapter gives details of how to do hardware installation for C168H/PCI and connection option
(Opt8x).
Chapter 3 Software Installation
This Chapter describes the software installation, board and ports configuration, driver update and
removal for various operating systems: Windows NT, and Windows 95/98.
Chapter 4 Serial Programming Tools
This Chapter roughly describes the programming tools for various O.S. platforms, including PComm Lite
under Windows NT and Windows 95/98. Also, RS-485 programming issue is discussed (for Opt8J).
Chapter 5 Connection Option (Opt8x) and Cable Wiring
This Chapter describes the RS-232/422/485 cable wiring for each connection option (Opt8x).
Chapter 6 Troubleshooting
This Chapter describes error might happen and possible solutions for C168H/PCI.
Appendix Technical Reference
This chapter describes specification, PCI, UART, and DB62 pinouts.