Magellan 330 Series - Manual (Page 57)

45 Magellan MAP 330 GPS Receiver
Reference
Creating a GOTO Route — Creates and sets as the active route a 1-leg
route with your present position as the starting point and a destination
waypoint that you choose from the waypoint database.
From
Any
Screen
ENTER
ENTER Select
Waypoint
Category
Use L/R arrows
to select
“Find By”
GOTO
If a GOTO route
already exists, you will
be asked to clear it.
Select
Waypoint
from List
GOTO routes are not saved in memory. When you turn your MAP
330 off and then back on, the GOTO route is gone. You need to create
a new GOTO route if you intend on completing the route.
Also note that when you are selecting the Waypoint Category you are
being instructed to select the “Find By”. You can select only those
waypoints in your general vicinity (Nearest) or all of the waypoints in
the category in alphabetical order (Alphabetical).
Creating a Backtrack Route — Creates a route using track information
stored in the MAP 330 to “retrace” your steps. A good example of using
a backtrack would be if you were out hiking or jogging with your MAP
330 turned on and computing position fixes. After 30 minutes you
choose to return to where you started, following the same route you just
took. All you need do is follow the instructions below and let the MAP
330 take you there.
From
Any
Screen
MENU ENTER Highlight
Routes
Select
“Backtrack”
from Route List
Highlight
Activate Backtrk
ENTER
ENTER