Miller Electric ICE-100T - Manual (Page 37)

.
A complete Parts List is available at www.MillerWelds.com
OM-201 872 Page 33
40 Amp Machine Torch Shielded Consumables
The following cut charts are based on a distance of 1/16 in (1.6 mm) between torch and workpiece for all cuts.
212 733 212 732 212 734 212 724 212 725
Swirl Ring Electrode Tip Retaining Cap Shield ICE-100TM Torch Sense Tab*
226 763
*Shield sense tab 226 763 provides feedback to a compatible torch height controller before starting the cutting process.
.
Shield sense tab is located in the consumable storage box on left side of unit wrapper.
Mild Steel
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay Inches mm IPM mm/min IPM mm/min
142 0.25 14 ga 1.9 640 16,256 221 5,613
40
146 0.5 10 ga 3.4 151 3,835 98 2,489
40
147 0.75 3/16 4.7 97 2,464 63 1,600
149 1 1/4 6.4 74 1,880 48 1,219
Stainless
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
141 0.25 18 ga 1.3 592 15,037 335 8,509
144 0.25 16 ga 1.5 374 9,500 243 6,172
40
144 0.25 14 ga 1.9 221 5,613 144 3,658
40
147 0.5 10 ga 3.4 107 2,718 70 1,778
149 0.75 3/16 4.7 67 1,702 44 1,118
149 1 1/4 6.4 47 1,194 31 787
Aluminum
Arc Current Arc Voltage
Pierce
Delay
Material Thickness Maximum Cut Speeds Optimum Cut Speeds
Arc Current Arc Voltage
Pierce
Delay
Inches mm IPM mm/min IPM mm/min
145 0.25 3/32 2.4 293 7,442 190 4,826
40 149 0.5 1/8 3.2 204 5,182 133 3,378 40
151 1 1/4 6.4 76 1,930 49 1,245
Without concern for cut appearance, the fastest speed for cutting material is the maximum cut speed. For better cut angle, less dross, and cut surface
appearance, use the optimum cut speed. The values in the cut charts are basic starting points and each application may require some adjustment to
achieve the best cut characteristics.