Motorola TMS320C6711D - Manual (Page 85)

TMS320C6711D
FLOATINGĆPOINT DIGITAL SIGNAL PROCESSOR
SPRS292A − OCTOBER 2005 − REVISED NOVEMBER 2005
85 POST OFFICE BOX 1443
•
HOUSTON, TEXAS 77251−1443
RESET TIMING (CONTINUED)
Phase 1 Phase 2
11
10
9
8 7
6 5
4 3
14
13
2
1 1
CLKIN
ECLKIN
Internal Reset
Internal SYSCLK1
Internal SYSCLK2
Internal SYSCLK3
RESET
Phase 3
EMIF Z Group†
EMIF Low Group†
Z Group†
Boot and Device
Configuration Pins‡
2
2
2
CLKOUT3
ECLKOUT
CLKOUT2
12
Z Group 2†
† EMIF Z group consists of: EA[21:2], ED[31:0], CE[3:0], BE[3:0], ARE/SDCAS/SSADS, AWE/SDWE/SSWE, AOE/SDRAS/SSOE and
HOLDA
EMIF low group consists of: BUSREQ
Z group 1 consists of:
CLKR0, CLKR1, CLKX0, CLKX1, FSR0, FSR1, FSX0, FSX1, DX0, DX1, TOUT0, and TOUT1.
Z group 2 consists of: All other HPI and GPIO signals
‡ Boot and device configurations consist of: HD[8, 4:3].
Figure 40. Reset Timing
Reset Phase 1: The RESET pin is asserted. During this time, all internal clocks are running at the CLKIN
frequency divide-by-8. The CPU is also running at the CLKIN frequency divide-by-8.
Reset Phase 2: The RESET pin is deasserted but the internal reset is stretched. During this time, all internal
clocks are running at the CLKIN frequency divide-by-8. The CPU is also running at the CLKIN frequency
divide-by-8.
Reset Phase 3: Both the RESET pin and internal reset are deasserted. During this time, all internal clocks are
running at their default divide-down frequency of CLKIN. The CPU clock (SYSCLK1) is running at CLKIN
frequency. The peripheral clock (SYSCLK2) is running at CLKIN frequency divide-by-2. The EMIF internal clock
source (SYSCLK3) is running at CLKIN frequency divide-by-2. SYSCLK3 is reflected on the ECLKOUT pin
(when EKSRC bit = 0 [default]). CLKOUT3 is running at CLKIN frequency divide-by-8.