Marantz SR8001 - Manual (Page 20)

ENGLISH
17
IN OUT S-VIDEO IN OUT
2
1
SL L
R SR
FLASHER IN
IR RECEIVER IN
OUT
L E CD/CDR
OUT
MULTI OUT
R
O
UT
N
SR IN
SL
CB / PB CR / PR CR / PR CR / PR CB / PB CB / PB Y Y
SBR
SBL
SBR
SBL
C
SW
SW
C
1
2
EMITTER OUT
A B
OUT
PUT
1
OUT
PUT
2
OUTPUT 1 OUTPUT 2
UT 1(TV)
INPUT 4(DSS/VCR2) UT 3(VCR1)
T 4(DSS/VCR2)
HDMI
Ver1.2
INPUT 2(DVD)
DC OUT
PRE OUT
7.1CH IN
MULTI OUT DVD(2) DSS/VCR2(4) VCR1(3) TV(1) MONI. OUT
(AUX2)
XM
RS-232C
MODEL NO
AC XM
SL SL L L
R R SR SR
R R
L L
R R
L L
SR SR
SL SL
SBR SBR
SBL SBL
SBR SBR
SBL SBL
C C
SW SW
SW SW
C C
PRE PRE OUT OUT
7.1CH 7.1CH IN IN
( (AUX2 AUX2) )
L
R
FRONT SURR. SURR.
BACK
SUB
WOOFER
CENTER
L
R
FRONT SURR. SURR.
BACK
SUB
WOOFER
CENTER
R L R L R L
L R
R L
L R L R
R L
R L R L R L
R L
ADVANCED CONNECTING
CONNECTING MULTI CHANNEL AUDIO SOURCE
The 7.1CH INPUT jacks are for multichannel audio
source such as a Super Audio CD multichannel
player, DVD audio player or external decoder.
If you use these jacks, switch on the 7.1CH INPUT
and set the 7.1CH INPUT level by using the SETUP
MAIN MENU. See page25.
CONNECTING AN EXTERNAL POWER AMPLIFIER
The PREOUT jacks are for connecting external
power amplifi ers.
Be sure to connect each speaker to the corresponding
external power amplifi er.
Power
Amplifer
DVD Audio player
or
Super Audio CD
Multi channel player
Center Front
Left Front
Right
Surround
Left Surround
Right
Subwoofer
Surround
Back Left
COMPONENT VIDEO
IN OUT S-VID IN OUT
2
1
SL L
R SR
FLASHER IN
IR RECEIVER IN
OUT
6 COAX.
3
5 4
2 1
OUT
R
OUT
L TAPE CD/CDR
OUT IN
MULTI OUT
R OUT
L
DSS/VCR2
AUDIO
TV
IN
OPT.
IN
OUT
IN OUT
IN
SR
VCR1
IN IN
DVD SL
CB / PB CR / PR CR / PR CR / PR CB / PB CB / PB Y Y Y
SBR
SBL
SBR
SBL
S
S
1
2
EMITTER OUT
A B
VIDEO
FM (75 Ω) GND AM ANTENNA
OU
PU
1
OU
PU
2
INPUT 3(VCR1) OUTPUT 1 OUTPUT 2 INPUT 1(TV)
INPUT 1(TV)
INPUT 4(DSS/VCR2) INPUT 3(VCR1)
INPUT 4(DSS/VCR2) INPUT 2(DVD)
HDMI
Ver1.2
INPUT 2(DVD)
DC OUT DIGITAL IN DIGITAL OUT RC-5 MULTI RC
MONITOR OUT DVD(2) DSS/VCR2(4) TV(1) MULTI OUT VCR1(3) DVD(2) DSS/VCR2(4) VCR1(3) TV(1) MONI. OUT
(AUX2)
OUT OUT
IN IN
RC-5 RC-5
REMOTE
CONTROL
REMOTE
CONTROL
REMOTE
CONTROL
IN
OUT
IN
OUT
IN
OUT
EXTERNAL INTERNAL EXTERNAL INTERNAL EXTERNAL INTERNAL
1
RC OUT
2
CONNECTING THE REMOTE CONTROL JACKS
DVD player CD recorder
q
You can control other Marantz products through the
SR7001 with the remote control by connecting the
REMOTE CONTROL terminals on each unit.
The signal transmitted from the remote control is
received by the remote sensor on the SR7001. Then
the signal is sent to the connected device through
this terminal. Therefore you need to aim the remote
control only at the SR7001. Also, if a Marantz power
amplifi er (some models excluded) is connected to
one of these terminals, the power amplifi er’s, power
switch is synchronized with this unit’s power switch.
Set the REMOTE CONTROL SWITCH on the other
units, (not the SR7001) to “EXT.” (external) to use
this feature.
CD player
OPTION
w
Whenever external infrared sensors or similar devices
are connected to RC-5 IN of the SR7001, be sure to
always disable operation of the infrared sensor on the
main unit by using the following procedure.
1. Hold down the MULTI button and the MENU
button on the front panel at the same time for
fi ve seconds.
2. The setting “IR=ENABLE” is shown on the FL
DISPLAY.
3. Press the CURSOR buttons ( 1 , 2 ) to change
this to “IR=DISABLE”.
4. Press the ENTER button. Once this setting is
made, the infrared sensor on the main unit is
disabled.
Note:
• Be sure to set to “IR=ENABLE” when external
infrared sensors or similar devices are not connected.
Otherwise, the main unit will be unable to receive
remote control commands.
5. To restore the original setting, perform steps 1
to 4 to set to “IR=ENABLE”.
Surround
Back Right