Marantz SR8001 - Manual (Page 58)

55
ENGLISH
PRESET SCAN
D4
D5
D2
M
D1
D3
D5
D4
USE PAGE 2 2.
3.5.
DSS
AMP AUX2 AUX1 TAPE
TUNER CD CD-R MD
VCR DVD TV
1 2 LIGHT
Learning Remote Controller RC8500SR
TUNER
1.
2 3 1
5 6 4
OK
VOL CH
PREV MUTE
MENU EXIT
GUIDE
TEST CH.SEL
LIP.SYNC
SURR
7.1CH ATT SPK-AB
DISP OSD SLEEP
CH
5.
1. Press the TUNER button twice within two
seconds on the remote.
2. Press the > button until PAGE 2 is displayed.
3. press the P-SCAN (D4) button on the remote
control unit. “PRESET SCAN” appears on the
display and then the preset station with the
lowest preset number is recalled fi rst.
4. Preset stations are recalled in sequence (No.1
→ No.2 → etc.) for about 5-10 seconds each.
The time changes by the received condition.
No stored preset number will be skipped.
5. Pressing the CH+ button during prescanning
speeds up scanning.
Also, pressing the CH– button returns to the
previous preset station.
When the desired preset station is received,
cancel the preset scan operation by press the
P-SCAN (D4) button.
CLEARING STORED PRESET STATIONS
You can remove preset stations from the memory
using the following procedure.
DIGITAL S-VIDEO AUX
V
DOWN
MultEQ ENTER A/B
T-MODE MEMORY CLEAR
DISPLAY
EXIT
SPEAKERS
BAND
MIC
ER
L C R SL S SR LFE DIGITAL SURROUND V-OFF ST SPKR A B NIGHT PEAK ANALOG DIGITAL ATT DISC 6.1 MT X 6.1 EQ
PCM AAC
3. 2.
2 3 1
5 6 4
8
0
9 7
MEMO CLEAR
DSS
TUNER CD CD-R MD
VCR DVD TV
TEST CH.SEL SURR
7.1CH ATT SPK-AB
DISP OSD
THX
SLEEP
MEMO CLEAR MEMO CLEAR
2.
3.
1. Recall the preset number to be cleared with
the method described in ”PRESET SEARCH
MODE”.
2. Press the MEMORY button on the front panel
or Press the MEMO button on the remote.
3. The stored preset number blinks in the display
for 5 seconds. WhiIe blinking, Press the CLEAR
button on the front panel or the remote.
4. “xx CLEAR” appears on the dispIay to indicate
that the specified preset number has been
cleared.
Note:
• To clear all stored preset stations, press and hold the
CLEAR and the ENTER buttons for two seconds.
• There are 60 preset channels prepared at the factory
default. The 60 channels are all set to “CHANNEL
001”. Each channel can be stored in the preset
memory. You can search for only the preset
channels.