Marantz SR8001 - Manual (Page 24)

ENGLISH
21
a RS232C
Connect an external control device or other device for
servicing. (Use a straight cable for the connection.)
s DC OUT (DC TRIGGER)
External devices can be controlled from the SR7001
by connecting them to the DC OUT terminal (12 V).
d EMITTER OUT (SR8001 Only)
Outputs the remote control signal input to the IR
RECEIVER IN terminals. External components can
be controlled by connecting them to the EMITTER
OUT terminal.
f FLASHER IN
This receiver can be controlled by connecting a
control box or other control device to this receiver.
MPONENT
VIDEO
IN OUT S-VIDEO IN OUT
2 2
1 1
SL L
R SR
FLASHER FLASHER IN IN
IR IR RECEIVER RECEIVER IN IN
OUT
AX.
SURROUND BACK
OUT
L TAPE CD/CDR
ON
OFF
OUT IN
MULTI OUT
R OUT
SS/VCR2
AUDIO
T.
OUT
IN
SR IN
SL
CB/PB CR/PR CR/PR CR/PR CB/PB CB/PB Y Y Y
SBR
SBL
SBR
SBL
C
SW
SW
C
R
L
R
L
1 1
2 2
EMITTER EMITTER OUT OUT
A B
UNSWITCHED 1.25A 150W MAX
AC OUTLETS
120V 60Hz
SWITCHED 1.25A 150W MAX
OUT
PUT
1
OUT
PUT
2
INPUT 3(VCR1) OUTPUT 1 OUTPUT 2
INPUT 1(TV)
INPUT 4(DSS/VCR2) INPUT 3(VCR1)
INPUT 4(DSS/VCR2)
HDMI
Ver1.2
INPUT 2(DVD)
DC OUT DC OUT
PRE
OUT
RC-5 MULTI RC
7.1CH
IN
MONITOR OUT S/VCR2(4) MULTI OUT DVD(2) DSS/VCR2(4) VCR1(3) TV(1) MONI. OUT
(AUX2)
XM
RS-232C RS-232C
MULTI SPEAKER
/SPEAKER C SUB SPEAKER
MODEL NO. SR8001
AC IN XM
g s
a
f d
CONNECTING OTHER EQUIPMENT
g IR RECEIVER IN (SR8001 Only)
This receiver can be operated by remote control
without using the internal IR receiver, by connecting
an external IR receiver.
+12V
GND
Signal
An IR receiver is connected as shown above.
Caution:
• Wrongly connecting an IR receiver or connecting
an IR receiver of the wrong voltage can damage the
SR7001, therefore do not do this.
• 50 mA of current are supplied to the device connected
to the IR RECEIVER IN terminal.
• Connecting a device that requires more than 50 mA
of current to this receiver will damage this receiver.
Before using other devices, carefully check the
specifi cations of those devices.