Magellan NAV 6500 - Manual (Page 37)

Magellan NAV 6500/NAV 6510 29
Creating a GOTO Route to the Cursor Position
GOTO
Move cursor
to destination Modify or
Accept Default
Data
ENTER Done
Only if destination is not an
existing waypoint
Press GOTO from any screen except the Auxiliary and full
map screens. The Map screen appears.
Move the cursor over the desired destination point and press
ENTER.
If no waypoint already exists at the cursor position, the
Create GOTO Waypoint window appears.
Use the CURSOR KEY and ENTER to modify the name,
type and description, if desired, and press Done.
Creating a GOTO route automatically deletes any
previous GOTO route. If the previous GOTO
route was a GOTO MOB, you must confirm to
delete it.
A solid line shows the GOTO route created from the present
position to the cursor position.
Creating a MOB Route
GOTO MOB
The MOB, or Man Overboard, function allows you to in-
stantly create a GOTO route to the position at which you
press the GOTO key and MOB softkey.
Press GOTO from any screen except the Auxiliary and full
map screens. The Map screen appears.
Press the MOB softkey.
A GOTO MOB has been created to the position at which
you pressed the MOB softkey.
When a GOTO MOB has been created, it remains
in memory until you set another route or GOTO.
A confirmation window then appears: Activate
New GOTO, Delete GOTO MOB?
Deleting a GOTO Route
GOTO ESC
Confirm
Delete
Press GOTO from any screen except the Auxiliary and full
map screens. The Map screen appears.