Marantz DV7600 - Manual (Page 42)

DVD Setup Menu 6
42
About source audio output
When the source output mode has been switched between the 5.1 Channel and 2 Channel (Stereo or Lt/Rt)
mode settings using the Audio Out setting in the Setup screen Audio menu, audio output for each source will be as
shown in the following table.
*1 : Discs that prohibit downmixing will be output as 5.1channel even if 2 Channel
(Stereo) is selected.
*2 : If the sound is mono, Lch and Rch audio will be the same.
*3 : Set Digital Out (page 39) to Off for DVD Audio 192/176.4/96/88.2 kHz Hi
Sampling and 5.1 channel analog output.
AUDIO
CONTENTS
OUTPUT
MODE
AUDIO OUT (2 CH)
5.1 CH
Other
5.1 CH/
Other
5.1 CH
Other
5.1 CH/
Other
5.1 CH/
Other
DV
D
CD
Super Audio CD
Video CD
Dolby
Digital
LPCM
DTS
DVD
-Audio
Front Lch, Rch
2 ch DOWNMIX Lch, Rch or Lt/Rt
2 ch DOWNMIX Lch, Rch
Center Surround LS, RS
2 ch DOWNMIX Lch, Rch or Lt/Rt
Lch, Rch
AUDIO OUT (5.1 CH)
Lch, Rch
Front Lch, Rch
L, R (Front L,R) Center Surround L,R Sub Woofer
*2
*1
Center Surround LS, RS LFE
LFE
MUTE
MUTE
MUTE
Lch, Rch
MUTE
MUTE
5.1 CH/
Other
DVD-RW Lch, Rch MUTE
5.1 CH
Other
Front Lch, Rch Center Surround LS, RS LFE
MUTE
5.1 CH Front Lch, Rch Center Surround LS, RS LFE
2 ch DOWNMIX Lch, Rch
*3
5.1 CH
Other 2 ch DOWNMIX Lch, Rch
Front Lch, Rch Center Surround LS, RS LFE
MUTE
Other
MPEG
MUTE
Audio DRC
• Default setting: Off
When watching Dolby Digital DVDs at low volume,
it’s easy to lose the low level sounds completely,
including some of the dialog. Switching on Audio
DRC (Dynamic Range Compression) can help
things by bringing up the low level sounds, while
keeping the lid on high level peaks.
The Off setting leaves the original dynamics intact;
On ‘squashes’ the dynamics; but exactly how much
difference you can hear between the settings will
depend on the material you’re watching.
Remember
• Audio DRC is only effective with Dolby Digital
audio sources.
• The effect of Audio DRC depends on your
speakers and AV amplifier settings.