Muratec Fax Machine - Manual (Page 104)

Advanced fax
F-Code transmission and polling
With F-Code, your machine can send secure transmissions, perform relay broadcast
initiations and even poll from other
ITU - T -equipped machines, regardless of manu-
facturer.
You can do this two ways:
• Using the programmable one-touch key (see pages 3.54–3.60).
• Entering the
ITU - T sub-address and password directly, which is what we’ll
describe here.
Note: For F-Code communication to work, three things must be true:
• The remote fax machine must support ITU - T sub-addressing
• The remote fax must have a mailbox with an ITU - T sub-address created
on it
• You must know the ITU - T sub-address and password (if any) for the
remote machine’s mailbox
F-Code transmission
1 Place the document and select the resolution and contrast you require.
2 If you want to toggle between manual transmission and memory transmis-
sion, press
MEMORY TRANSMIT .
3 Press MENU and select “F-Code Tx”.
4 Press [Enter].
5 Use the numeric keypad to enter the appropri-
ate sub-address in the remote machine.
Note: If you make a mistake, press [Clear] to
erase the character, then enter the cor-
rect number.
6 Press [Enter].
7 Use the numeric keypad to enter the password.
Note: If this sub-address does not have a password, skip to step 8.
8 Press [Enter].
9 Enter the fax number either by pressing a one-
touch key, entering a speed-dial number or
dialing from the numeric keypad.
Important: Do not press START , if you want
to delay this transmission.
10 What you do now depends on when you want
the transmission to begin.
• To have it begin now, skip to step 13.
• To delay it, go on to step 11.
11 Press MENU , select “Delayed Tx” and then
press [Enter].
The
LCD shows (see right):
12 Use the numeric keypad to enter the day and
time when the transmission should begin, then
press [Enter].
13 Press START .
If in step 10 you chose an immediate transmission, your fax machine begins dialing.
If you chose a delayed command, the machine shows “Reserved” on the
LCD , indicat-
ing that it has stored the command in memory and will complete it later.
F-Code polling
1 Press MENU and select “FCodePolling”.
2 Press [Enter].
3 Use the numeric keypad to enter the appropri-
ate sub-address in the remote machine.
Note: If you make a mistake, press [Clear] to
erase the character, then enter the correct number.
4 Press [Enter].
5 Use the numeric keypad to enter the password.
Note: If this sub-address does not have a password, skip to next step.
6 Press [Enter].
3.52