Muratec Fax Machine - Manual (Page 93)

F
ax F
eatures
Getting Started
To set the printing one of these reports:
1 Press MENU , G , [Enter].
2 Select “ReportType” then press [Enter].
3 Select confirmation report type “TCR” or
“RCR” by using the cursor key.
4 Press [Enter] to save the setting.
5 To print the selected report automatically after
every fax you send, select “Report”, and then
press [Enter].
6 Select “ON” using the cursor key.
7 Press [Enter] to save the setting.
To turn the confirmation report feature on or off for
only the next fax transmission, press
REPORT .
What happens next depends on the setting you chose:
• If the light next to the
REPORT key glows, the fax machine will print the
confirmation report automatically.
• If the light next to the REPORT key doesn’t glow, the fax machine will not print a
confirmation report.
After you send this transmission, your machine returns to the setting you chose in
step 2, above.
Numbering pages
Just before sending a fax, you can set your fax machine to number each page. This
will help the person receiving the fax to keep track of all the pages.
To set up page numbering:
1 Count the number of pages in your document.
2 Set your document in ADF or FBS glass.
3 Adjust the resolution and contrast, if necessary.
4 Press NEXT until [#OfPages] is appeared.
5 Press [#OfPages].
6 Use the numeric keypad to enter the number of
pages in your document.
7 Press [Enter].
From here, continue sending the document using
whatever type of transmission you need (broadcast, group dial, etc.). When the
remote fax machine prints the document, a note on the right side of your
TTI will
indicate the number of the page — such as “ P .02” for page two.
Advanced fax
3.41