Muratec Fax Machine - Manual (Page 57)

3.5
Basic fax
7 If you want to send more pages, proceed to step 8.
Otherwise, press
START to start the transmission, and skip to step 9.
8 Place the next page, then press [Start] to start scanning.
To send any more pages, repeat this step.
Otherwise, press [Exit] to start the transmission, and skip to step 9.
9 Now, everything is up to the machines — yours and the one you’re dialing.
When it makes contact, your machine transmits the stored document from
memory.
Note: If you want to cancel a transmission while scanning the document,
press the STOP key.
If you want to cancel a transmission in progress, use the Job Review
function. See “Canceling commands” on page 3.6.
10 After transmission, the machine beeps and return to its standby mode.
Note: If the call fails, see “Redialing,” page 3.6.
Sending a fax using monitor/call or a handset
You may also fax a document using either the monitor speaker or the optional hand-
set to dial.
1 Place the document in the ADF .
Note: In this function, you cannot use the FBS glass.
2 Adjust resolution and contrast if necessary.
3 Obtain a dial tone, either by:
• Pressing
MONITOR / CALL
… or …
• Lifting the optional handset.
In either case, the LCD shows (see right):
4 Enter the fax number.
Also, enter access codes with the number, just as for a regular phone call.
5 When you hear fax tones from the remote unit, press START .
Note: If a person answers the phone, use the optional handset to tell the
person you’re trying to send a fax. When you hear fax tones, press
START .
6 If you’re using an optional handset, hang up after pressing START .
7 After transmission, the machine beeps and returns to its standby mode.
Note: If the call fails and you used MONITOR / CALL to dial, press
MONITOR / CALL to hang up. Or if you’ve pressed START to begin the fax
transmission, press STOP to end it.
Also see “Redialing manually,” next page, if the call fails.
Overseas transmission mode
This mode instructs your fax to compensate for the poor transmission
characteristics of some overseas telephone lines. To set overseas mode:
1 Enter the fax number using the numeric keypad.
2 Press NEXT until the [Overseas] is appeared.
Then press [Overseas].
Note: This feature automatically deactivates itself
following each dialing.
F
ax F
eatures
Getting Started