Invacare IH6300ADH User Manual
Page 15
SECTION 3—OPERATION
15
Operating Shower/Massage Wand
NOTE: STEPS 1 ‐ 3 are to be performed while holding the shower/massage wand over the tub. Refer to
Features on page 8 for additional illustrations.
1. Turn shower/massage wand on to desired flow by rotating knob.
2. Adjust water temperature while watching thermometer.
3. Adjust shower spray by rotating shower wand head.
NOTE: Refer to the following chart for shower head adjustment settings.
4. Turn shower On/Off knob to Off position when finished.
Filling the Tub
1. Close the drain.
2. Turn tub fill On/Off valve to On position by rotating knob.
3. Adjust water temperature while watching thermometer.
4. Turn tub fill On/Off valve to Off position when water reaches desired level.
NOTE: If hydromassage use is anticipated, water level MUST be completely above whirlpool jets.
NOTE: Before starting hydromassage, open the whirlpool inlet and whirlpool jets.
Using Hydromassage
CAUTION
Before starting hydromassage, water level MUST be completely above whirlpool jets
otherwise damage to the motor/pump will result.
1. Open the whirlpool inlet by pushing in on the plug in the whirlpool inlet fitting.
2. Open all whirlpool jets by performing one of the following:
• Turn the center of the jet counter‐clockwise to a full stop.
• Pull the center of the jet out.
3. Add Invacare Defoamer to bath water. Refer to Defoamer bottle for directions.
4. Push whirlpool On/Off button to start whirlpool jets.
5. Adjust the whirlpool aerator for desired water agitation by rotating the knob.
6. After use, push whirlpool On/Off button to stop whirlpool jets.
7. Drain the tub.
Stream
Shower Spray
Mixture of Spray and Pulse Massage
Pulse Massage