Invacare IH6300ADH - Manual (Page 9)

SECTION 1—GENERAL GUIDELINES
Part No 1096926 9 Supine Bath Tub
SECTION 1—GENERAL GUIDELINES
ƽ WARNING
SECTION 1 - GENERAL GUIDELINES contains important information for the safe
operation and use of this product.
Check all parts for shipping damage before using. In case of damage, DO NOT use the
equipment. Contact the ICCG dealer for further instructions.
Installation
ICCG assumes no responsibility for code infractions or damage to components due to
improper installation.
Use extreme care during installation.
The installation area MUST be able to support the 66 pounds per square inch load
capacity of the Supine Tub.
After installation and before use ensure all parts are properly and securely installed.
Ensure bathroom floor is dry and free of obstructions before transporting or assembling
unit.
Be certain ALL electrical work is performed by a qualified electrician and is in compliance
with local electrical codes.
Electrical
Grounding Instructions
Model IH6300 Supine Tub MUST be direct wired to wall using hot, neutral and ground
wires in accordance with the National Electrical Code. External wiring MUST be
grounded through a 15 amp breaker and GFCI receptacle.
Model IH6300ADH Supine Tub MUST be plugged into a hospital grade GFCI receptacle
with a 15 AMP breaker.
Plumbing
Be certain ALL plumbing work is performed by a qualified plumber.
Some state and local plumbing codes require the installation of a “reduced pressure zone”
(RPZ) assembly on both the incoming hot and cold supply lines to prevent back flow
contamination into the potable water system. Invacare recommends you check local
plumbing code requirements to determine if RPZs are required on your tub installation.
RPZs are NOT supplied by Invacare and are to be provided by the customer if required.
The hot water supply to the tub MUST NOT exceed 110° F (43° C) to protect the user from
scalding.