Invacare IH6300ADH - Manual (Page 17)

SECTION 4—INSTALLATION
Part No 1096926 17 Supine Bath Tub
SECTION 4—INSTALLATION
Preparing the Work Area
NOTE: For this procedure, refer to FIGURE 4.1.
1. Determine location for the supine bath tub installation.
NOTE: Follow recommended floor plan when installing tub.
2. Carefully remove the tub from carton.
3. Remove tub from shipping pallet by removing screws from leg mounting pads.
4. Model IH6300 ONLY ‐ Remove the screws that secure the rear access panel to access
the pump electrical connections (Detail “A” of FIGURE 4.1).
FIGURE 4.1 Preparing the Work Area
3 ft
(914 mm)
Wall
94 inches (2388 mm)
38 in.
(965 mm)
142 inches (3606 mm)
Screw
(1 of 4)
Access
Panel
Leg Mounting Pads
DETAIL "A"
3 ft
(914 mm)
3 ft
(914 mm)
1 ft
(304 mm)