Securing the tub – Invacare IH6300ADH User Manual
Page 18
SECTION 4—INSTALLATION
18
Securing the Tub
NOTE: For this procedure, refer to FIGURE 4.1 on page 17 and FIGURE 4.2.
1. Set the tub in place.
2. Mark location of anchor holes, using pre‐drilled holes in leg mounting pads as a
template (Detail “A” of FIGURE 4.1).
3. Move tub away from mounting area.
ƽ WARNING
Protective eye wear MUST be worn when drilling to avoid possible eye injury.
4. Drill anchor holes in floor. Use a jack‐drill with a carbide bit for concrete floors or a
wood bit for wood floors.
5. Reposition the tub in mounting area, aligning the holes in the leg mounting pads with
the holes drilled in STEP 4.
ƽ WARNING
DO NOT adjust height of legs more than 1 inch (25.4 mm); leg will disassemble
from leg mounting pad and serious injury may occur.
6. Level the tub by adjusting the telescopic legs either up or down, using a wrench, to
achieve the desired height.
7. Check to make sure tub is level by placing a level on the front and sides of the tub
(Detail “A” of FIGURE 4.2).
8. Repeat STEPS 6 and 7 until tub is level.
9. Secure legs to floor using fasteners appropriate for the floor material and in keeping
with local codes (Detail “B” of FIGURE 4.2).
FIGURE 4.2 Securing the Tub
DETAIL “A” - LEVELING
Level
Level
Leg
Leg Mounting
Pad
Anchor
1-inch (25.4 mm)
Maximum Adjustment
DETAIL “B” - SECURING TUB
Lag Bolt
Leveling
End to End
Leveling
Side to Side
Lag Bolt
Anchor