Intel LAN+Modem56 PC Card PRO/100 - Manual (Page 81)

Windows 3.x/MS-DOS Installation 4-43
If nondefault configuration settings are used, these must be stated on the
M16BPD.COM command line. For example,
M16BPD IOADDRESS=320 INT=7
ETHDRV
Driver Keyword Alphabetical Reference
? displays a summary of command line options.
COMx specifies which COM port the PRO/100 PC Card
should use when providing serial port emulation
for modem operations. Values for x can be 1, 2, 3,
or 4. Each of these values instructs the driver to
use pre-defined values for I/O address and
interrupt level, and to enable the specified I/O
address in the COM port BIOS table. The modem
driver IMENABLE.COM defaults to COM3. Use
the keywords COMIRQ and COMBASE to
override the values set with COM1, COM2,
COM3, or COM4 in case of a conflict between
LAN and modem settings.
COMBASE can be used to override the pre-defined I/O port
value for a specific COM port in case of a conflict
between LAN and modem settings. It can also be
used with COMIRQ to select a user-defined COM
port. Default is no keyword. Parameter setting is a
hexadecimal value in the range 248 to 3F8 which
must be different from the value used with the
IOADDRESS or PORT keyword. Serial emulation
mode requires 8 addresses.
COMIRQ is used to override the pre-defined interrupt value
for a specific COM port in case of a conflict
between LAN and modem settings. It can also be
used with COMBASE to select a user-defined
COM port. Default is no keyword. Parameter
setting is a decimal value which must be different
from the value used with the INTERRUPT
keyword.