Intel LAN+Modem56 PC Card PRO/100 - Manual (Page 91)

Windows 3.x/MS-DOS Installation 4-53
The AUTODRV.INI file is used to assign resources to the PRO/100 PC
Card. The AUTODRV.INI file should be edited to read as follows:
ETHERNET.
CARDID=ETHER,CREDI
;OPTION=IGNORE (THE SEMICOLON IS REQUIRED)
PORT1=320, IRQ=5, MEMORY1=C800, WAITSTATE=1
The same resources should be specified in the PRO/100 PC Card driver
initialization file.
Phoenix
The Phoenix Card and Socket Services super client driver PCMSCD.EXE
should NOT be configured with the PCM.EXE program to support the
PRO/100 PC Card. Use the default setup and the following sequence of
commands in your CONFIG.SYS file.
DEVICE=C:\PCMPLUS3\PCMSS.EXE
DEVICE=C:\PCMPLUS3\PCMCS.EXE
DEVICE=C:\PCMPLUS3\PCMRMAN.SYS
DEVICE=C:\PMCPLUS3\PCMSCD.EXE (CALLED A “GENERIC” CARD DRIVER)
Be sure to verify that an EMM386 memory exclusion has been stated to
cover the region where the Intel card loads.
SystemSoft
The SystemSoft’s CardSoft Card and Socket Services are loaded in the
CONFIG.SYS file and generally include the following lines:
DEVICE=C:\CARDSOFT\SOCKET_SERVICES_DRIVER (THIS FILE VARIES
BY MACHINE TYPE)
DEVICE=C:\CARDSOFT\CS.EXE
DEVICE=C:\CARDSOFT\CSALLOC.EXE C:\CARDSOFT\CSALLOC.INI
DEVICE=C:\CARDSOFT\CARDID.EXE (CALLED A “GENERIC” CARD DRIVER)
Resources assigned by CardSoft Card and Socket Services are controlled
by the files CSALLOC.INI and CARDID.INI. CSALLOC.INI contains a
list of resources available to Card and Socket Services. CARDID.INI
controls how resources will be assigned to specific types of cards. The
setting in the PRO/100 PC Card driver configuration file should match