9 wheels and casters, Warning, 1 removing/installing the drive wheels – Invacare Lynx L-3X User Manual
Page 36: Removing, Remove keystock from drive shaft. set aside
9 WHEELS AND CASTERS
36
9 Wheels and Casters
9.1
Removing/Installing the Drive Wheels
Removing
1.
Turn power off and remove the key from the ignition.
2.
Remove the seat. Refer to Removing/Installing the Seat on page 27.
3.
Place the rear frame assembly (not shown) up on blocks so that the drive wheels are off the ground.
4.
Remove the cap, nut, large washer and small washer that secure the drive wheel to the drive shaft.
5.
Remove the existing drive wheel assembly from the drive shaft.
6.
Remove keystock from drive shaft. Set aside.
7.
If necessary, repeat STEPS 1-6 to remove other drive wheel.
ƽ
WARNING
After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely -
otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power Off and remove key from ignition.
For this procedure, refer to FIGURE 9.1 on page 37.
Use a wheel puller if necessary to remove the wheel from the drive shaft.