11 transporting, Warning, 1 transporting the scooter – Invacare Lynx L-3X User Manual
Page 49: Disassembling, Remove any installed accessories, Hold the seat post with one hand, Assembling
11 TRANSPORTING
49
11 Transporting
11.1 Transporting the Scooter
Disassembling
1.
Turn power off and remove the key from the ignition.
2.
Remove any installed accessories.
3.
Remove the seat. Refer to Removing/Installing the Seat on page 27.
4.
Remove the batteries. Refer to Removing/Installing the Batteries on page 35.
5.
Disconnect the tiller wiring connector from the controller wiring connector
(Detail “A”).
6.
Hold the seat post with one hand.
7.
With the other hand, push the release lever to the rear of the scooter (Detail “A”).
8.
Lift the seat post to separate the front frame assembly from the rear frame assembly pins.
9.
Fold tiller down to lowest locked position. Refer to Adjusting the Tiller Angle on page 31.
Assembling
1.
Unfold tiller. Refer to Adjusting the Tiller Angle on page 31.
2.
Position the rear frame between the curved locking brackets of the front frame assembly.
ƽ
WARNING
After any adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely -
otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and remove key from ignition.
DO NOT lift the scooter by the rear shroud - otherwise damage to the scooter may occur.