Invacare Lynx L-3X - Manual (Page 50)

11 TRANSPORTING
Lynx™L-3X Scooter 50 Part No. 1145807
3. Hold the seat post and align the curved locking brackets on the front frame assembly with the rear frame assembly pins.
4. While holding the seat post, slowly lower the front frame assembly onto the rear frame assembly pins until the release lever locks.
5. Connect the tiller wiring connector to the controller wiring connector.
6. Install the batteries. Refer to Refer to Removing/Installing the Batteries on page 35.
7. Install the seat. Refer to Removing/Installing the Seat on page 27.
8. If necessary, install any accessories to be used.
FIGURE 11.1 Transporting the Scooter
Release
Lever
DETAIL “A”
Rear
Frame
Assembly
Front
Frame
Assembly
Tiller Wiring
Connector
Controller Wiring
Connector
Seat
Front Frame Assembly
Curved Bracket
Rear Frame
Assembly Pins
Front Frame
Assembly