Invacare Lynx L-3X - Manual (Page 44)

10 BATTERIES
Lynx™L-3X Scooter 44 Part No. 1145807
A. RED battery terminal cap onto RED battery cable.
B.
GREY battery terminal cap onto BLACK battery cable.
2. Connect battery cables to battery terminals:
A. NEGATIVE (-) BLACK battery cable to NEGATIVE (-) battery terminal/post.
B.
POSITIVE (+) RED battery cable to POSITIVE (+) battery terminal/post.
3. Secure the battery cables ring terminal to the battery terminals, BLACK to NEGATIVE (-) and red to POSITIVE (+), with the provided mounting
bolt and locknut. Securely tighten.
4. Verify all battery cables ring terminal are correctly installed and securely tightened.
5. Slide terminal caps down battery cables and onto battery clamps.
6. Position the batteries on the scooter. Refer to Removing/Installing the Batteries on page 41.
\
7. If necessary, charge the battery(ies). Refer to Charging the Batteries on page 46.
8. Install the rear shroud. Refer to Removing/Installing the Rear Shroud on page 44.
9. Install the seat. Refer to Removing/Installing the Seat on page 34.
ƽ WARNING
When connecting the battery cables to the batteries, the battery cables MUST be connected to the battery terminals/posts
as shown in FIGURE 10.3, otherwise
damage to the battery cable may result when installing battery terminal caps.

New batteries MUST be fully charged before using, otherwise the life of the batteries will be reduced.