Invacare Lynx L-3X - Manual (Page 37)

9 WHEELS AND CASTERS
Part No. 1145807 37 Lynx™L-3X Scooter
Installing
1. Place keystock in cutout on drive shaft as shown in FIGURE 9.1.
2. Install the drive wheel onto the drive shaft.
3. Secure wheel to drive shaft using the large washer, small washer and
nut. Securely tighten.
4. Install the cap onto the nut.
5. Repeat STEPS 1-4 to install the other drive wheel.
6. Install the seat. Refer to Removing/Installing the Seat on page 27.
FIGURE 9.1 Removing/Installing the Drive Wheels
 The keystock in the drive shaft MUST lineup with
the cutout in the wheel hub.
If necessary, use a rubber hammer to gently tap
drive wheel completely into position on the drive
shaft.
Keystock
Drive
Shaft
Small Washer
Nut
Drive Wheel

Scooter not shown.
Cap
Large
Washer