Ice-O-Matic GEM0956R - Manual (Page 26)

GEM0650/0956/1256 Remote Operation: Water
Page 20
Water
Water enters the machine through the 3/8 inch male flare at the rear of the cabinet, goes to the water reservoir
which it enters through the float valve. The water then goes out the bottom of the reservoir tank to the bottom
of the evaporator. Reservoir overflow or evaporator condensation is routed to the drain.
Water Level
The correct water level should be checked when the machine is making ice. Locate the water level in the
reservoir, and compare it to the horizontal line molded into the side of the reservoir. The correct level should
be between 1/8 inch above and 1/4 inch below the line. If needed, bend the float arm up or down to adjust the
water level.
Water System
Water Inlet
Reservoir
Ice Chute
Drain
Evaporator Drain
Water Level
Evaporator Water Inlet