Invacare Wheelchair XP6500 - Manual (Page 35)

SECTION 6—FRONT RIGGINGS
Part No. 1123839 35
Replacing the Heel Loop
NOTE: For this procedure, refer to FIGURE 6.3.
1. Pull the cam lock lever up to the unlocked position.
2. Push in the release buttons and remove the lower footrest assembly.
3. Remove the mounting screw, spacer and locknut that secure the heel loop to the
footrest.
4. Remove existing heel loop from slide tube.
5. Install new heel loop onto slide tube.
6. Install the mounting screw, spacer and locknut to secure the heel loop to the footrest.
Tighten until the spacer is secure.
FIGURE 6.3 Replacing the Heel Loop
7. Insert the lower footrest assembly into the upper footrest assembly to desired height.
8. Ensure that the release buttons fully protrude from holes on both sides of the upper
footrest support.
9. Rotate cam lock lever down to locked position.
Raising/Lowering the Legrest Assembly
ƽ WARNING
Ensure hands and fingers are clear of elevating legrest mechanism before pushing
release lever to lower the elevating legrest. Otherwise injury may occur due to
pinch points.
The wheelchair user’s leg MUST be supported by an assistant before attempting to
lower legrest.
Lower Footrest
Assembly
Slide Tube
Spacer
Locknut
Mounting Screw
Cam Lock Lever
Footrest
Heel Loop