Invacare Wheelchair XP6500 - Manual (Page 54)

54 Part No. 1123839
SECTION 11—BATTERIES
FIGURE 11.7 Connecting Battery Cables
Replacing Battery Box Retaining Strap
ƽ WARNING
The battery box retaining strap MUST be fastened securely and adjusted properly
to hold battery boxes in place before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 11.8 on page 55.
1. Remove the battery boxes from the wheelchair. Refer to Removing/Installing the
Battery Boxes on page 49.
2. Remove the battery tray from the wheelchair. Refer to Installing/Removing Battery
Tray on page 50.
ƽ WARNING
The retaining strap MUST be fed through the adjustable end of the battery box
retaining strap buckle as shown in FIGURE 11.8.
NOTE: Take note of the position and orientation of the battery box retaining strap as it passes
through the slots of the battery tray and the adjustable end of the battery box retraining strap
buckle.
1/4-20 x 7/8-Inch
Hex Flange Screw
Detail “A” - Dual UI Batteries
NEGATIVE (-)
Terminal/Post
1/4-20
Hex
Flange
Locknut
POSITIVE (+)
Terminal/Post
Connect Cable
Ring Terminal
to This Side of
Terminal/Post
POSITIVE (+)
Terminal/Post
NEGATIVE (-)
Terminal/Post GREY
Terminal
Cap
ORANGE
Terminal Cap
Tie-Wraps
Detail “B” - Installing Battery Terminal Cap onto Battery Cable
Cable
Terminal Cap
NOTE: For clarity, only one cable
and terminal cap are shown. Both
caps install in the same manner.