Invacare Wheelchair XP6500 - Manual (Page 40)

40 Part No. 1123839
SECTION 8—SEAT AND BACK
Replacing the Back Upholstery
NOTE: For the following procedure, refer to FIGURE 8.2.
1. Flip swing back arms up and out of the way. Refer to Swing-Back Arms on page 38.
2. Remove the six mounting screws and washers that secure the existing back upholstery
to the back canes.
3. Cut the tie wraps that secure the existing back upholstery to the wheelchair frame.
4. Securely tighten the new back upholstery to the back canes with the six mounting
screws and washers starting with the top hole of the back cane.
5. Install two new tie wraps through the bottom holes of the upholstery to the bottom of
the back upholstery to the back canes.
6. Flip swing-back arms down for use. Refer to Swing-Back Arms on page 38.
FIGURE 8.2 Replacing the Back Upholstery
Mounting Screws
Washers
Back Cane
Back Upholstery
Washers
Mounting Screws
Tie Wraps