Invacare Wheelchair XP6500 - Manual (Page 51)

SECTION 11—BATTERIES
Part No. 1123839 51
Installing/Removing Batteries Into/From Battery Boxes
ƽ WARNING
Make sure power to the wheelchair is Off before performing this procedure.
The use of rubber gloves is recommended when working with batteries.
ProBasics strongly recommends that battery installation and battery replacement
ALWAYS be done by a qualified technician.
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
NOTE: For this procedure, refer to FIGURE 11.5 on page 52.
NOTE: For changing or removing/installing the battery boxes, refer to Removing/Installing the
Battery Boxes on page 49.
NOTE: To remove the battery(ies) from the battery box(es), reverse the following procedure.
NOTE: Have the following tools available:.
ƽ WARNING
Always use the battery handle when lifting the battery. It is the most convenient
method and assures that the battery acid will not spill. It also helps to prolong the
life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
NOTE: If there is battery acid in the bottom or on the sides of the battery box(es) or battery(ies),
apply baking soda to these areas to neutralize the battery acid. Before reinstalling the new or
existing battery(ies), clean the baking soda from the battery box(es) or battery(ies).
NOTE: When securing battery lifting strap to battery, observe polarity markings located on the
ends of the battery lifting strap, (+) side to POSITIVE (+) battery terminal/post and (-) side to
NEGATIVE (-) battery terminal/post.
1. If necessary, remove the battery boxes from the wheelchair. Refer to
Removing/Installing the Battery Boxes on page 49.
2. Secure the battery lifting strap to battery terminal(s)/post(s).
TOOL QTY COMMENTS
1/2-inch (6 pt.) Box Wrench 1 Not Supplied
7/16-inch (6pt) Box Wrench 1 Not Supplied
3/8-inch (6pt) Box Wrench 1 Not Supplied
Diagonal Cutters 1 Not Supplied