InSciTek Microsystems Allworx Phone - Manual (Page 15)

Phone Guide
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be
trademarks or registered trademarks of their respective owners.
Revised: March 28, 2007
Page 11
5 Phone Operation
5.1 Answering / Placing a Call
• Lift the handset off the hook.
• Press the Speaker button to put the phone in hands-free mode or headset mode, if the headset is
connected.
• Using the keypad without lifting the handset will place the phone in speakerphone mode.
• PFKs that can be used to answer incoming calls (if flashing) or make outgoing calls:
o Call Appearance
Can be used to either place an extension-to-extension call, or to obtain an outside line
by first dialing 9.
o Line Appearance
Do not have to dial 9 to obtain outside line.
o Call Monitor
o Call Queue
o Speed Dial
Automatically dials the programmed number
Note: Unless configured otherwise, incoming calls to your phone will ring the audible indicator, flash the
Allworx visual indicator (only applies to the 9112), and flash one of the Call Appearance PFKs.
5.2 Ending a Call
• If you’re using the handset, place receiver back on the hook.
• If you’re using the speakerphone, make sure the handset is on hook, then press the Speaker button.
• If you’re using a headset, press the Speaker button.
• Pressing another PFK will end the call.
o If a second call is coming in on another PFK, by pressing that PFK your current call will end and
the incoming call will be answered.
• Press the Release button to end a call and start a new call.
5.3 Headset
1. Plug the cable for the headset into its receptacle on the right side of the phone.
2. Press the Speaker button. (You cannot use the speakerphone and headset at the same time).
3. When you are finished with the call, press the Speaker button to disconnect.