Phone guide – InSciTek Microsystems Allworx Phone User Manual
Page 22
Phone Guide
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2007 InSciTek Microsystems, Inc. All rights reserved. Allworx is a registered trademark of InSciTek Microsystems. All other names may be
trademarks or registered trademarks of their respective owners.
Revised: March 28, 2007
Page 18
Note: Do not Blind Transfer to 700, as the call will be disconnected.
1. Press
the
Transfer button.
2. Select a second Call Appearance PFK.
3. Dial extension 700.
4. The parking location will be announced (701 – 709).
5. Press
the
Transfer button again. The call is now parked in the announced location.
Blind Park
A call may be parked by making a Blind Transfer to extension 740.
1. Press
the
Transfer button.
2. Dial extension 740.
Park PFK
A System Administrator can set a PFK on a phone to Park calls.
• To park an active call, press the Park PFK.
o
The parking location will not be announced. The phone display can show the extension (701 -
709) where the call is parked, if Parking Orbit Popups are enabled (Section 7.3).
Note: When a Park PFK is defined, the Hold button only ever operates as Hold. The current user
preference setting for Hold Button Operation (Section 7.3) is ignored and Park is not available using
the Hold button.
Park a Call using a Line Appearance PFK
An incoming call on a Line Appearance PFK can be parked using the Hold button.
Note: The Phone must be programmed for Key System Behavior.
1. Answer the incoming call using the Line Appearance PFK.
2. Press the Hold button, and the call will be parked.
a. Any other phone that is monitoring the same outside line will be flashing red and can pick up the
call.
• To perform a Privacy Hold, continue to press the Hold button past the time it takes to Park the call. The
call will be on Privacy Hold for that particular phone. Any other phone that is monitoring the same
outside line will be solid red and cannot pick up the call.
• If the Hold button is held, it will toggle back and forth between Park and Hold.
Parking a Call from the Hold Screen