IBM F50 RS/6000 7025 User Manual

Page 226

Advertising
background image

Removing a Disk Drive, Tape Drive, or CD-ROM from Bay A or Bay B

Note: To locate bay A or bay B, see the illustration given on page 5-81.

To remove a drive from bay A or bay B, do the following steps:

1. If you have not already done so, remove the covers as described in “Removing

Both the Front and Side Covers” on page 5-10.

2. Locate the drive you want to remove.

3. Slide the drive halfway out of the front of the bay.

4. Disconnect the cables from the back of the drive.

5. Remove the drive from the bay. Store the drive in a safe place.

6. Go to Table A-2 on page A-4 and update the drive information; then return here

to determine your next step.

7. If you are removing another internal drive from bay A or bay B, return to step 2.

8. If you are installing another internal drive in bay A or bay B, go to step “Installing

a Disk Drive, Tape Drive, or CD-ROM in Bay A or Bay B” on page 5-44.

9. If you have other procedures to perform, refer to “Option List” on page 5-17.

10. If you do not have any other procedures to perform, replace the covers as

described in “Replacing Both the Front and Side Covers” on page 5-96.

5-82

IBM RS/6000 7025 F50 Series User's Guide

Advertising