IBM F50 RS/6000 7025 - Manual (Page 306)

Step 11
1. If the terminal type has not been defined, you must use the Initialize
Terminal option on the Function Selection menu to initialize the operating system
environment before you can continue with the diagnostics. This is a separate and
different operation than selecting the console display.
2. Select Diagnostic Routines.
3. Press the Enter key.
4. In the following table, find the menu or system response you received when you
selected Diagnostics . Follow the instructions given in the Action column.
System Response Action
The Diagnostic Mode Selection menu is
displayed. Select Problem Determination and go to “Step
12.”
The Missing Resource menu is displayed. Follow the displayed instructions until either the
Diagnostic Mode Selection menu or an SRN is
displayed.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to “Step 12.”
If you get an SRN, record it, and go to “Step
14.”
The New Resource menu is displayed. Follow the displayed instructions.
Note: Devices attached to serial ports S1 or
S2 will not appear on the New Resource
menu. Also, ISA adapters do not appear
unless they have been identified and
configured.
If the Diagnostic Mode Selection menu is
displayed, select Problem Determination and go
to “Step 12.”
If you get an SRN, record it, and go to “Step
14.”
If you do not get an SRN, go to “Step 17.”
The system does not respond to selecting
diagnostics
Go to “Step 10.”
9-6 IBM RS/6000 7025 F50 Series User's Guide