IMC Networks FiberLinX - Manual (Page 30)

HUBCTRL32 Installation Instructions
Software and Hardware Requirements
HUBCTRL32 for Windows NT requires the following:
l
Windows NT version 4.0 or higher.
l
The same hardware requirements for Windows NT plus a network
interface card.
l
Internet Explorer 4.0 service pack 2 or higher required for the Help
to work.
HUBCTRL32 for Windows 98 requires the following:
l
Windows 98.
l
The same hardware requirements for Windows 98 plus a network
interface card.
l
Internet Explorer 4.0 service pack 2 or higher required for the Help
to work.
NOTE: HUBCTRL for DOS is also available. Please contact IMC
Networks’ Technical Support at 800-624-1070 (in U.S.) or via e-mail
at [email protected] for more information.
Downloading HUBCTRL32
From the IMC Networks Web site:
1) Download the file hubctrl32.exe from IMC Networks’ Web
site. The file can be found under the section “Other” at:
http://www.imcnetworks.com/tech/software.htm
2) Use Windows Explorer to locate the downloaded file. Double
Click the file to start. A “Welcome” dialog box for the
HUBCTRL32 Setup Program will appear.
3) Click Continue. The Setup program will launch.
4) Proceed to the “Installing HUBCTRL32 for Windows NT and
Windows 98” section on the next page.
From the iView CD:
1) Using Windows Explorer, browse the iView CD and double-
click on the file SETUP.EXE located in the directory HC32/.
2) Follow the on-screen instructions.
3) Proceed to the “Installing HUBCTRL32 for Windows NT and
Windows 98” section on the next page.
Ap.4