IMC Networks FiberLinX User Manual

Page 32

Advertising
background image

9) As stated earlier, the Networking Control Panel application will

launch once you finish the Setup Utility. Here you must install

the drivers necessary for running HUBCTRL32. At this window,

do the following:

For Windows 98 Network Control Panel Application

A) Highlight an adapter to bind HUBCTRL32 to.
B) Click

the

Add... button.

C) Select Protocol from the list then click the Add...

button.

D) Click Have Disk..., then Browse.
E) The install INF and packet drivers can be found in the

directory C:\Program Files\Hub Control32 or the

directory specified in the Choose Destination Location

dialog box (see 4, above). Select this directory,

highlight the file SNMPpkt.inf and click OK, then click

OK again.

F) The correct directory for the driver will already be

displayed, click OK to install the new driver.

G) Restart the system to complete the HUBCTRL32

installation.

For Windows NT Network Control Panel Application

You MUST have Administrator rights to perform the

following steps. If you do not you will need to LOGOFF and

LOGON on as Administrator.

A) Click the Protocols tab.
B) Click

the

Add... button, then Have disk...

C) Enter C:\Program Files\Hub Control32 or the directory

specified in the Choose Destination Location dialog

box (see 4, above) in the box, then click OK.

D) Click OK to select the SNMP Ndis3 protocol.
E) Click

Close... to bind the new protocol.

F) Restart the system to complete the HUBCTRL32

installation.

If you experience any problems, please contact IMC Networks technical

support at (800) 624-1070 (in U.S.), +32-16-550880 (Europe) or via e-mail

at [email protected]
For information regarding the use of HUBCTRL32, please refer to the

HUBCTRL32 online Help file (Start, Programs, Hub Control32).

Ap.6

Advertising