Raising/lowering elevating legrest assembly, 5 front riggings, Warning – Invacare TRACER EX2 User Manual
Page 35
5 FRONT RIGGINGS
35
Fixed Frame
1.
Remove impact guards and/or calf strap, if necessary.
2.
Loosen, but do not remove the bolt and locknut that secure the
lower footrest assembly to the upper footrest support.
3.
Reposition the lower footrest assembly to the desired height.
4.
Securely tighten the bolt and locknut.
5.
Repeat this procedure for the other footrest, if necessary.
6.
Replace impact guards and/or calf strap, if necessary.
5.3
Raising/Lowering Elevating Legrest Assembly
1.
To raise the elevating legrest, the assistant should hold the support
tube and raise the elevating legrest until the desired height is
obtained.
2.
To lower the elevating legrest, perform the following:
A. Support user leg with one hand.
B.
Push release lever downward with other hand.
C. Gently, lower user leg down and rest against the legrest.
FIGURE 4 Adjusting Footplate Height - Fixed Frame
FIGURE 5 Raising/Lowering Elevating Legrest Assembly
ƽ
WARNING
Ensure hands and fingers are clear of elevating legrest
mechanism before pushing release lever to lower the
elevating legrest. Otherwise injury may occur due to
pinch points.
The wheelchair user’s leg MUST be supported by an
assistant before attempting to lower legrest.
Bolt and
Locknut
Wheelchair Frame
Footplate
Assembly
Release Lever
Support Tube