Replacing rear wheel handrim – Invacare TRACER EX2 User Manual
Page 48
8 REAR WHEELS
48
8.3 Replacing Rear Wheel Handrim
1.
Remove the rear wheel from the wheelchair. Refer to Removing/
Installing Rear Wheels on page 46.
2.
Remove the mounting screws that secure the handrim to rear wheel.
3.
Remove the existing handrim.
4.
Secure the new handrim to the rear wheel with mounting screws.
Tighten securely.
5.
Reinstall rear wheel to the wheelchair. Refer to Removing/Installing
6.
Repeat STEPS 1-5 for the opposite rear wheel if necessary.
FIGURE 2 Replacing Rear Wheel Handrim
ƽ
WARNING
If the wheelchair is equipped with permanent axles,
this procedure MUST be performed by a qualified
technician.
ƽ
WARNING
Make sure the detent pin and detent balls of the
quick-release axles are fully released and
protruding out of the hole before operating the
wheelchair.
Keep detent balls clean.
Mounting Screw
Rear Wheel
Handrim